1. Home
  2. Community Brag Posts

Kitty Tree Condo

Submitted by Proto on Tue, 11/13/2012 - 15:21

I adapted the simple Kitty Tree plan to make an outdoor sunroom for my cats. They are locked inside when I'm away, so this was a way for them to get some fresh air. They can access it via a tunnel, visible on the side as a grey box that butts up against the panel for the cat flap.
It's 36"X30" and 68" high.
The walls are made of plexiglas and I made the interior ramps by cutting up a set of wooden shelves.Plexiglas is expensive, but I salvaged some that was slightly scratched and going to the landfill. Otherwise, it would have cost me well over $100.
The frame was built using a Kreg jig, which is now my new favourite tool. I also added some casters so it can be rolled away from the wall for cleaning.
I found the Kitty Tree plan to be easy and versatile.

Estimated Cost
$25 for lumber and plywood, $15 for exterior paint, $150 for plexiglas
Estimated Time Investment
Weekend Project (10-20 Hours)
Finish Used
Exterior latex. a mis-tint I got for cheap.
Recommended Skill Level
Intermediate

Comments

Proto

Mon, 11/19/2012 - 06:42

The plexiglas is not quite large enough to cover the space between the posts so there is a 1/8" inch gap around many of the edges.
Also the back is open. When it's away from the wall, I can lean in to clean it. So, it's not at all airtight.

Proto

Mon, 11/19/2012 - 06:45

One could use a wire mesh instead of plexiglas to save money. It would look okay, especially if painted, but I splurged on the plexiglas because it does look nicer than wire. I wanted to prevent complaints from our immediate neighbours if they thought a wire cage was an eyesore.

babysteps

Mon, 11/19/2012 - 07:04

Your cats are going to love this. Once the birds (thinking about swallows) figure out they can swoop by quickly without harm, the birds are going to love it too. You could even put a bird feeder nearby to make it more interesting for the cats to look at.