Simple Adirondack Side Table

simple outdoor side table
Difficulty
Beginner Projects
| Print this plan

Free outdoor side table plans.  This is a beginner friendly project plan with step by step diagrams, shopping and cut list

And following, you'll find plans to make a simple matching side table!

Dimensions
simple outdoor side table
Dimensions are shown above

Preparation

Shopping List
  • 2 - 1x3 @ 8 feet long
  • 1 - 1x4 @ 8 feet long
  • 1 1/4" exterior deck screws
Cut List
  • 2 - 1x3 @ 14 1/2"
  • 3 - 1x3 @ 15"
  • 4 - 1x3 @ 16 1/4"
  • 5 - 1x4 @ 18 1/2"
Tools
Tape Measure
Speed Square
Pencil
Safety Glasses
Hearing Protection
Drill
Circular Saw
Drill Bit Set
General Instructions

Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!

Instructions

Step 1

First, build the basic table frame. You can attach boards in different ways, the easiest is just using a countersink bit to drill holes and attach with screws and glue. Alternatively (Kreg jig users) you can use 3/4" pocket holes and 1 1/4" pocket hole screws.

Step 2

Attach legs to outside of frame as shown in diagram.

Step 3

Mark the tabletop boards and place on top of the tabletop. Predrill holes and attach - overhangs are shown in next diagram ...

Step 4

Enjoy your side table!!!

Finishing Instructions
Preparation Instructions
Fill all holes with wood filler and let dry. Apply additional coats of wood filler as needed. When wood filler is completely dry, sand the project in the direction of the wood grain with 120 grit sandpaper. Vacuum sanded project to remove sanding residue. Remove all sanding residue on work surfaces as well. Wipe project clean with damp cloth.

It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.

Comments

skenyonobrien

Mon, 07/06/2020 - 08:47

I cannot find pressure treated 1x3s in my area. Can i use another more common pressure treated board? I’m brand new to this so if this is a dumb question, I’m sorry!!!