Built from plans on this website, with some modifications.
i used 8-ft x 16-in x 3/4-in edge-glued boards from Lowe’s for the shelves. Instead of cutting the boards to length, I widened the console slightly to accommodate.
I added an extra shelf to increase storage. I also added vertical dividers between the shelves to increase strength and prevent sagging.
The top is an 8-ft x 20-in edge-glued board with a piece of 1x4 board added on at each end. I then added strips of 1x2 underneath on all sides to create an overhang. The top is not fastened on with screws or any other fasteners. Its weight keeps it in place, and being removable will make it easier to move the console, if necessary, in the future.
I couldn’t find a commercial stain that had the “red barn” look I wanted, so I used latex paint thinned with an approximately equal amount of water.
The top is painted with three coats of Sherman Williams “Caviar” (not thinned).
For a protective finish, I used four coats of Minwax Wipe-on Water-based Polycrilic on the top. I decided I didn’t like the wipe-on poly, though — wiping it on was too messy on my hands — so I switched to brush-on for the rest of the project. That received three coats in critical areas, two coats in places unlikely to see much wear.