Community Brag Posts

Hailey Wall Magazine Rack

Submitted by dave_83 on Sat, 06/14/2014 - 23:03

This was my first ever project. I initially intended to use it for office storage but it ended up taking its place in the kitchen - and proving most useful for storage there too!

Estimated Time Investment
Afternoon Project (3-6 Hours)
Finish Used
Colron wood dye - American Walnut
Recommended Skill Level
Starter Project

Comments

CaitCouch

Submitted by Anonymous (not verified) on Tue, 09/13/2016 - 09:31

We altered our plans as my dining room could only accomodate a 7 ft table! This was out first DIY that was this large of an undertaking and we love the way it came out. If we can do this as woodworking novices you can definately do it! 

Estimated Cost
$150 in the philadelphia area including wood, screws, stain, and finish another $75 if you need to rent a mitre saw.
Estimated Time Investment
Week Long Project (20 Hours or More)
Finish Used
Sanded down the table starting with 150 grit, followed by 220, then 320. Next, MinWax English Chestnut (1 coat- painted on and sat for 5 mins and then wiped off with rags- we didnt time it just about 5 mins - did the top first- then sides- then the legs one at a time to make it more manageable) followed by MinWax Satin Matte polyurethane (2 coats- 5 hours between coats and then sit for 48 hours untouched)

It was suggested to us that before attaching we should sand, stain and seal the legs. We didn't follow this advice from a friend and we should have!! being down on the ground with the table is all together was very hard on our backs and bottoms (and were in our 20s!). that is the only thing i would have done differently.
Recommended Skill Level
Beginner

Bed porch swing

Submitted by Anonymous (not verified) on Sun, 06/28/2020 - 09:45

Utilized your plans for this porch bed swing! Looks great on the porch. Couldn’t find anything solid in the ceiling to hang it from so I installed my own joists with rafter hangers attached to the walls. Should hold long term.

Built from Plan(s)
Estimated Cost
$80 in Wood and $20 in stain and polyurethane
Estimated Time Investment
Weekend Project (10-20 Hours)
Finish Used
Spar Urethane
Mocha stain
Recommended Skill Level
Beginner

Mom's fancy California King

Submitted by danaxboo on Sat, 08/25/2012 - 08:58

Mom's Fancy Farmhouse in California King, Glazed.

I used the headboard measurements from the original plan, and the width/length measurements from the California King plan. My first plan was to distress (above picture) and I loved it, but when I brought it downstairs it didnt really match... So I repainted and Glazed :) Not to bad for buying my first "power tool" less than a month ago!!

Estimated Cost
Under $250 (paint, stain, hardware, wood, everything!!)
Estimated Time Investment
Day Project (6-9 Hours)
Finish Used
Antiqued white, glazed with Jacobean
Recommended Skill Level
Beginner

Farmhouse dining table with straight legs

Submitted by isti799 on Wed, 06/18/2014 - 22:12

I'm homemade woodworker. This is my first job!

Estimated Cost
100 $
Estimated Time Investment
Weekend Project (10-20 Hours)
Finish Used
2 coat waterbased stain ( trilak vekonylazur)
3 coat+1 coat tabletop waterbased furniture varnish (Trilak vizes butorlakk)
Recommended Skill Level
Beginner

Comments

West Elm Wall Cubby Knock Off

Submitted by Mike F on Sun, 09/18/2016 - 06:15

My wife found this post on Pinterest and asked if i could build it.  The hardest part was cuting the angles wit the jig saw because i can never get it to cut square and i have a little OCD about that sometimes.  I ended up using my table saw a little.  I would not recommened that though.  If i had acess to a band saw stand that would have ben perfect.

Estimated Cost
Around twenty dollars
Estimated Time Investment
Afternoon Project (3-6 Hours)
Finish Used
I used two different stains, provincial and special walnut.
Recommended Skill Level
Beginner

Narrow Cottage End Table from Scraps

Submitted by kmgoff30 on Tue, 06/30/2020 - 16:55

I loved this project so much!! The best part of it for me was I didn't spend any money! I literally used scrap boards I had from rehab projects I had completed around my little cozy cottage. Some of the boards were already painted in Polar Bear by Behr in gloss finish. The other boards are unfinished common boards. Including this room I finished 2 weeks ago!

Estimated Cost
0
Estimated Time Investment
Day Project (6-9 Hours)
Finish Used
Some of the boards are natural and some are painted with Polar Bear by Behr in gloss finish.
Recommended Skill Level
Intermediate
Back