Community Brag Posts

X- console

I built this coffee table from the Taylor's Coffee Table plans (http://ana-white.com/2014/02/plans/taylors-coffee-table) with a few "artistic"/necessary liberties.  For the top, I used a slightly different pattern than shown on the plans.  Starting from one side to the other, my plan includes a 1"x2", a 2"x6", a 2"x2", two side-by-side 2"x6", a 2"x2", a 2"x6", and finally a 1"x2".  I liked the extra overhang that the 1"x2" included on the outside edges of the table.

I do not own a jigsaw, so instead of making the entire bottom shelf out of plywood, I made a "border" with 1"x4" boards with the adjoining corners cut at 45 degrees so that each side of the border matched up nicely.  This allowed me to use a standard rectangular piece of plywood for the shelf "inlay."  

As a first attempt at any sort of table, this turned out much better than I could have hoped!

I have had this space under my television that I never knew what I should do with it. There is a baseboard heater on the wall so I always figured I could put anything against it. I also have a lot of shoes. When I saw the plans for the vegetable bin I figured I could convert it to hold my shoes. 

I used 1x8s for the middle legs allowing the cabinet to sit over my baseboard heater. I adjusted the height of each cubby to fit the various sizes of shoes I own. I put 1x4s along the back so as to allow everything to breath. It took me about 2 days to complete. 

Super easy. Done in less than one hour. Used Target's Black-Out curtains.

We used the least expensive pine at Lowe's because I really like the variation in the wood.  I think it adds character.  This was the first time I've used Weathered Oak and boy is it sheer!  You can hardly tell it's there over the dark walnut but it did seem to lighten it just a little and give a slight grey to the very dark areas.  Really liked the outcome!

This was my first project with drawers, and I learned through sad experience how important it is to have ULTRA straight boards to begin with! I am grateful for things like itty-bitty washers to help correct things that aren't quite straight enough. More info on my blog!

This is my first DIY furniture build.  Had some issues with the Poly, but it turned out better than I thought.  I used a couple of Turnbuckles with black hammer spray paint instead of the back slant supports.  Made some mistakes, but learned a lot.  Thanks Ana for the great site and all of the great posts.

I assisted a friend in building a loft bed for her daughter.  We followed free plans by Ana White for the junior loft bed. We made a few modifications such as changing it to fit a full-sized mattress (more details on my blog). The loft bed is the largest furniture item that I have built thus far. I have learned a lot from working on the project.

My very first woodworking project. I learned a lot. Most importantly, to watch my cuts more carefully. Also, a good stain and stencil dress up anything. I used braided jute for handles and love them!

I built this little hall tree, bench and shoe organizer for the garage entirely from scrap lumber and left over paint.  Keeps us organizeed.  I really like it.

Of all of my Ana White-inspired builds, this is absolutely my favorite so far and the first piece of furniture I've built that I absolutely want to use as the centerpiece and inspiration for my DIY redecorating. I slightly modified the height of the top compartments so that all of our electronic equipment would fit.  I also used 2x4's, which I ripped into 2x2's using an old blade where I slightly bent a couple of the teeth to leave the rustic curf marks.  Because I altered the height of the top and bottom sections, I had to rip down my 1x3's for the bottom, and I had to use 1x4's (ripped down appropriately) for the top section's flip-down faux drawer fronts.