Community Brag Posts

I started building a different bench, but I decided halfway through that I didn't like my design. I found this, and loved it, so I modified my partially built bench to incorporate the woven back design. I substituted in a few mortise and tenon joints for strength, and used either kreg or waterproof glue for the non-structural joints. The seat bottom is made from 2x4's I resawed in half. I also rounded over the edges of the 'Y' pieces, which I think makes it look a bit more like they're woven together. Thanks for the plans, this is a great addition to my front porch!

This table was a cinch to put together and only took a couple of hours

My dad and I built these chairs by following Ana's Adirondack plan, and then adding our own curved back. We also routed all the edges to give the entire chair a rounded feel. We also built the simple little round side table to use with the chairs.

This cart was smaller then I expected but makes a great little addition to my office

Followed the plans closely. Stained before assembly for the two color look.

My wife started looking at expensive patio sets, which I thought were not worth the price, so I decided to build a picnic table. This is not the cheapest table out there, but it's built to last for years!! I used a high quality cedar as I got a price cut from a friend. I also used deck screws, so there would be no rusty screws!! The table top measures 7' long and looks like one you would see at a state park, notHome Depot!

I took the original plans from the Farmhouse Table - Updated Pocket Hole Plans - and I modified it so that my table could be countertop height and join up to my counter -  like a modified breakfast bar, so this table it countertop high, and is also more narrow and alittle longer.  I can easily pull it away from the wall and sit 6 people around it.  It is now my favorite place in the house!  

My husband and I built this on Sunday- I love how it turned out!  The hardest part was finding cushions, and carrying it up a flight of stairs!

I built this using the plans for the Perfect End Table. I made it a little taller and jazzed up the shelf a bit.  The whole project cost me less than $35!

I had a lot of fun with this project! It was quick, and I already had everything I needed on hand. I have been wanting to get more practice with my jigsaw and this project was perfect for that. I used one cedar picket for the whole box and still had some left over. I added a burlap bow and made the tail with some extra pieces of rope and my glue gun. It was a breeze!

This is the table I made for my wife using 2x lumber...I used the epoxy resin finish and it gives it a beautiful look and finish...my wife, family and friends love it...I'm very pleased with how well it turned out...

Today I built a workbench from wood found in my alley. No money was harmed during the making of this workbench #renew #reuse #recycle

Started with the classic bunk bed plan. Changed most of the 1x4s to 1x3 except the boards at the mattress level. Added an additional rail up top to make safer for my young children. Also added 1x3s on both ends of the head/foot board to make the legs a litter sturdier and to widen the frame as our mattresses turned out to be a little wider than standard. Took out the built in ladder and matched the rest of the rails. Then added detachable stairs to be able to remove during the day and make it easier for my girls to get up and down. Made a few mistakes along the way (when you write 57.5 inches and transfer 52.5 inches to your cut list you eventually have a really bad/sad day), but had a ton of fun!

This was super easy. Just make sure you bolt it to the studs in the wall. I bolted them to each other and to the wall for added support. It only took me the afternoon and then I stayed up all night to finish it and get it done. I made this system over 3 years ago and it still works great for our family.