Community Brag Posts

Thanks for the plans on the simple bench

My FIRST carpentry project! Good thing my husband was willing to help as it was a little heavy and I was googling terms like "counter-sink."  It would have been so much easier if we hadn't made it a birthday surprise for my daughter. She LOVES it! 

I purchased choice 2x4s and was so sad to see how much sanding the planks still required, even with an electric rotary sander. That added a few hours-perhaps because I am such a beginner! 

We used a white nylon rope which matched her room better, but again, increased the cost a bit.

I am really proud of the results! 

Followed the plan until we decided on a bottom shelf.  Where there's a will there's a way. Made it a little bit harder but well worth it 

It took the husband and I a good 3 days to finish this project. You can read more of my experience with this chaise on our blog:
http://tonyandkristine.blogspot.com/

For the plans, I found them at Lazy Liz on Less blog:
http://lazylizonless.blogspot.com/2012/05/it-took-me-while-to-decide-wh…

Thank you so much to Sausha and this site for the instructions, shopping list and measurements! I finally have my pedestal! No more back aches! I modified the height to 15" by making the posts to 6" and added center posts using 2x4.

This is a twist on the Rustic X console.  I made it wider, shorter and only did one shelf which is indented so the benches can both slide under for easy storage. 

I did this project for my father's birthday this February. Any ideas to improve it let me know. I hand drew the plaque on the back. I used some old brass when I went hunting in the past.

This is my Thank You Project.  I made this as was presented with the plans from my daughter and asked to make it.  Thanks to Ana White for posting great plans to follow.   This unit has been through five moves with teenagers doing the lifting.  There are no issues except I did repaint it.  http://ana-white.com/2011/12/plans/hillary039s-locker-cabinet-charging-cubbies This is my first project so I followed the plans exactly. 

Built this guitar stand basically by using on-hand materials left over from another project.  Used 1x12's; 18" tall fir for sides and back braces (cut at 5 degrees on each side).  Added felt strips to protect the instrument.

We followed the plan exactly as instructed, but instead of cutting the arch accents out of wood, we simply attached decorative shelving brackets to the legs.

This coffee table was my first build. Its a blend of mulitple coffee table designs by Ana White.

Pretty easy to make.  Lots of sanding time since you are working with 2x4s. Assembly was easy.

I made this plant stand using the adirondack stool plans. I did not leave spaces between the boards on the top, and I added breadboard ends.

I made this one huge! It is 6 feet by 6 feet. I handpainted the birds, and I used Ana's technique for painting on the letters.

Here is the 95% completed Fancy X Desk. The plans were very easy to follow. I would call it an intermediate level project simply because of the angle cuts. I had to reduce the size a little to fit our space. Built it in an afternoon and then applied one coat of primer and two coats of black paint. I have to wait until it is a little warmer outside to apply the poly as I didn't want to do it inside and my garage is about 30 degrees. I haven't figured out what it cost me to build but I feel comfortable saying it was hundreds less than it would have cost to buy at retail. Very excited about the result.